Welcome, Guest. Please login or register.
Did you miss your activation email?
October 15, 2018, 22:23:54 pm

Login with username, password and session length

Pages: [1]
Author Topic: Tool rapids when it should not  (Read 100 times)
Offline Offline

Posts: 79

View Profile
« on: October 09, 2018, 20:33:37 pm »

Hello to all,

   I ran across this problem today. I have done operations similar to this before and it has not happened.

Cambam version 1.0, latest revision is used.

Refer only to the active mop's in the attached cb file.

The first mop plunges (G81) to Z-.729 depth to give clearance for the next mop, which uses the same 5/8 endmill.

Instead of performing a rapid to the  minor grid unit above the stock height before feeding to the cutting depth, it just rapids directly to the cutting depth, ignoring the stock surface.

I have never had this happen before

Here is the job file and post processor.

Thanks in advance

Edit: I had a max crossover distance of 1 set in the mop.
I changed it to 0 and the problem went away, but am confused as to why that would make a difference.

* SDI SENSOR STRAP, AZI-GAMMA.cb (56.12 KB - downloaded 6 times.)
* Fanuc16i.cbpp (2.11 KB - downloaded 2 times.)
« Last Edit: October 09, 2018, 21:00:51 pm by jim1108 » Logged
Pages: [1]
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines

Valid XHTML 1.0! Valid CSS! Dilber MC Theme by HarzeM
Page created in 0.077 seconds with 19 queries.

Copyright © 2018 HexRay Ltd. | Sitemap