CamBam
News:
 
*
Welcome, Guest. Please login or register.
Did you miss your activation email?
November 13, 2018, 22:22:51 pm


Login with username, password and session length


Pages: [1]
  Print  
Author Topic: G-code ripper advice and help  (Read 730 times)
pierry
Storm Trooper
***
Offline Offline

Posts: 150


View Profile
« on: October 23, 2017, 00:26:02 am »

When i probe with ripper and the result become like the photo...
how can i lower it 0.01  in mach3 whitout to probe all over again Huh the ripper do so i can not adjust z level...it start over the whole proses with probing !!?Huh?


* spoon.jpg (175.61 KB, 1920x1080 - viewed 124 times.)
Logged
pierry
Storm Trooper
***
Offline Offline

Posts: 150


View Profile
« Reply #1 on: October 23, 2017, 01:46:37 am »

ok i did like this...put in the line you want to start . and set next line...ex. 348. then goto Z.. -0.01 , enter ..done...run..

maby usfull if some go in to same problem
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.21 | SMF © 2015, Simple Machines

Valid XHTML 1.0! Valid CSS! Dilber MC Theme by HarzeM
Page created in 0.081 seconds with 19 queries.

Copyright © 2018 HexRay Ltd. | Sitemap