Welcome, Guest. Please login or register.
Did you miss your activation email?
August 22, 2017, 07:55:57 am

Login with username, password and session length

Pages: 1 [2]
Author Topic: UFO Sighting!  (Read 443 times)
Arie kabaalstra
CNC Jedi
Offline Offline

Posts: 542

why buy one, if you can build one?

View Profile WWW
« Reply #15 on: August 20, 2017, 22:32:54 pm »

Not much CamBam going on.. as i turned the bezels for the cases..

here's a case with a bezel beside it..

and here's a bezel pressed on the case.. still not rounded off.. will do that manually, turning freehand on the watchmakers lathe.

Oh.. Wait up!.. there has been CamBamming in the last few days..

Milling the outer contour for the buckles.

and 3D profiling them..

so whe have this.. now to flip the part over, and do the bottom.

Which leads to this result..

and then.. after a few strokes with a fretsaw, calm and easy strokes, as Titanium is quite hard, and you can wear a blade down in mere millimeters if you go to fast..

I've already startef finishing the Buckles, and i learnt a lesson here.. i should have added an extra profiling MOp on the top, for get a smooth surface on the inside of the "Blade", i managed to smooth them though, but it took some time and elbow-grease..

CNC Jedi
Offline Offline

Posts: 7020

View Profile
« Reply #16 on: August 20, 2017, 22:56:53 pm »

Dang!  That "tiny" work always amazes me!


"Pyro for Fun and Profit for More Than Fifty Years"
Pages: 1 [2]
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines

Valid XHTML 1.0! Valid CSS! Dilber MC Theme by HarzeM
Page created in 0.126 seconds with 19 queries.

Copyright © 2008 HexRay Ltd. | Sitemap