Possible bug in Profile - CutOrdering

[dh42]

Hello Andy,

A friend send my a file that cause pb with cut ordering ; I have reproduced the problem on the attached file.

The pb appears only by changing the tool diameter ; on the first picture, cut ordering is OK for a tool of Ø6, the toolpaths are created as defined in the MOP settings (depht first), but the toolpaths are created in "level first" mode if I use a tool of Ø7.

Bug or not bug ?

++
David

[dh42]

Re

With the same file ; If I use a spiral leadin (angle = 0), toolpath are wrong ; look at the attached picture.

The orange toolpath as no leadin, and on the top left square, the second level don't start at the end of the first level.

 ++
David